
Software Manual 10
Setup PC IP Address
METHOD 1: PC to WAN /ETH0, Ethernet on SN-6000, RAM 9000
Type in ping 192.168.0.1 and then press the ENTER key
The display should look similar to the following:
METHOD 2: PC to ETH1: LAN on RAM 9000 only
Type in ping 192.168.1.1 and the press the ENTER key
The display should look similar to the following:
This shows the connection is up and functioning.
1.2.7 Installing RNDIS Driver for Ethernet Connectivity over USB
This section outlines the required method to manually install the correct RNDIS driver for your Red Lion device. This will
enable the unit to connect via USB and behave as an Ethernet device.
• Power on the Red Lion device and connect to your Windows PC via the USB micro cable.
• Observe the Microsoft Windows behavior to see if the unit is properly detected. An audible sound, as the cable is
connected, should be heard and Microsoft Windows begins searching for the correct USB driver.
• Most Windows systems will automatically locate and install a driver. The device would appear in the Windows
Device Manager as seen below:
Comentários a estes Manuais